I recently changed the probe for RAB 4-8L. Until the system is booting, I can read a message
RAB-L needs a MotCtrl firmware update to version: Mn_D00-06
where can I find and install it?
thank you.
Hi, Ilya! What is your SW version? This probe model is, probably, incompatible to it. Please, take a look at the manual to see the compatibility, otherwise, there is a possibility you should have a different Motor Control Board. Hope this helps. Take care, God Bless. MAC.
Comprehensive medical imaging support. We supply essential parts & maintenance for most OEMs, buy/sell quality used equipment, and offer mobile rentals globally. Contact us: info@lasoimaging.com
Ilya Zhukov
Voluson 730 Expert
November 09, 2013 07:43
I recently changed the probe for RAB 4-8L. Until the system is booting, I can read a message
RAB-L needs a MotCtrl firmware update to version: Mn_D00-06
where can I find and install it?
thank you.
to rate and post a comment
Marcelo Antonio Correa
re: Voluson 730 Expert
November 11, 2013 06:44
Hi, Ilya! What is your SW version? This probe model is, probably, incompatible to it. Please, take a look at the manual to see the compatibility, otherwise, there is a possibility you should have a different Motor Control Board. Hope this helps. Take care, God Bless. MAC.
to rate and post a comment
M.Y
re: re: Voluson 730 Expert
November 12, 2013 08:46
mac I need the software of 730 expert bt 02 if you have pl send me
to rate and post a comment
M.Y
re: re: Voluson 730 Expert
November 14, 2013 08:57
MAC
I need the software of valuson 730 expert bt 02 if you have or you can arrange me I will be thankfull
to rate and post a comment
Ilya Zhukov
re: re: Voluson 730 Expert
November 19, 2013 07:40
SW 2.2.1.1126 Is it BT02?
to rate and post a comment
Ricardo A. Sanchez
re: Voluson 730 Expert
November 13, 2013 06:44
what is the software versión for this system?
to rate and post a comment
M.Y
re: re: Voluson 730 Expert
November 13, 2013 08:34
bt02 730 expert
to rate and post a comment
Ricardo A. Sanchez
re: re: re: Voluson 730 Expert
November 13, 2013 04:06
the BT02 does not take the RAB4-8L, you need the RAB4-8P, thanks.
to rate and post a comment