I am about to complete installation of Axiom iconos R-200. When fluoroscopy is triggered,no image appears on TV screen. I found message from D10 saying, camera tube filament power supply out of tolerance. Also +6.5v LED on D1 was dimmer than other LED. The filament voltage was +3.8v instead of +6.5v. I changed the D1 board, the filament power supply was ok,image ok on TV,but after some time the same problem came up with D1 board. Where is the cause of this? I have cried out ohmic checks from D12 x200 camera cable connector, ok. Also voltage checks on D1 board test points, X204,x205,etc. Can D10 be faulty? Please help.
Sell your scrap MRI magnets! Top prices, free shipping, and fast pickups. Don't let dust-collecting, idle assets go to waste. Contact: ryan.swiderski@cyclicmaterials.earth or call 437-826-1621
Ogali Daniel
Videomed Sx
September 07, 2012 06:49
I am about to complete installation of Axiom iconos R-200. When fluoroscopy is triggered,no image appears on TV screen. I found message from D10 saying, camera tube filament power supply out of tolerance. Also +6.5v LED on D1 was dimmer than other LED. The filament voltage was +3.8v instead of +6.5v. I changed the D1 board, the filament power supply was ok,image ok on TV,but after some time the same problem came up with D1 board. Where is the cause of this? I have cried out ohmic checks from D12 x200 camera cable connector, ok. Also voltage checks on D1 board test points, X204,x205,etc. Can D10 be faulty? Please help.
to rate and post a comment
sohail aftab
re: Videomed Sx
September 08, 2012 09:32
please send me your email add or contact supermeditech@yahoo.com
to rate and post a comment
Ogali Daniel
re: re: Videomed Sx
September 08, 2012 04:29
my e-mail add: codemexee@yahoo.co.uk
to rate and post a comment