I have a problem on a senographe 800t mammo, the console only beeps at one second interval after power is supplied on its mains input. The on/off button on its power supply board has no response with the unit.
Hi Francis,
Did you check the DC/DC converter located on the right hand side of the cabinet. Power supply BD 300-PL9. It is a small box placed in the midle of the PCB. I think it converts 5 DC volts into 15 dc volts.
If it is correct,then you can check the LVPS 300 PL7, it is a comercial power supply. You can find it easily on the web.
I hope this helps you.
Francis Lienedes Ayson
Senographe 800t problem
May 20, 2008 11:22
I have a problem on a senographe 800t mammo, the console only beeps at one second interval after power is supplied on its mains input. The on/off button on its power supply board has no response with the unit.
to rate and post a comment
Daniel Fernandez
Re: Senographe 800t problem
June 03, 2008 07:29
Hi Francis,
Did you check the DC/DC converter located on the right hand side of the cabinet. Power supply BD 300-PL9. It is a small box placed in the midle of the PCB. I think it converts 5 DC volts into 15 dc volts.
If it is correct,then you can check the LVPS 300 PL7, it is a comercial power supply. You can find it easily on the web.
I hope this helps you.
to rate and post a comment