DearLazzari:
that is the latest software for the 4800. Verify the switch setting on the scsi board, mod setup, then connect everything to the console. The software will recognize the mod.
hi
you have to set some switches and jumpers on DISK SCSI boar. if u connecting the MOD from the rear of the console then you need a scsi card and if u connecting the same from front side of DISK SCSI, then u dont need.
if you software is not compatible to Y2K, then u need to bring the date back before 2K.or the mod will not work for software, although it work fine for image archinving.
good luck
Alessandro Lazzari
SCT 4800
March 15, 2005 06:24
Dear Sirs,
I need to know hardware & software setting
to connect an MOD (magneto optical drive) to consolle 4800
to rate and post a comment
Edwin Rosado
Re: SCT 4800
March 15, 2005 03:10
HI:
YOU NEED THE DISK SCSI BOARD, CABLE TO CONNECT THE MOD TO THE BOARD AND IF THE SYSTEM HAD THE LAST SOFWARE VERSION IS GOOD.
to rate and post a comment
Alessandro Lazzari
Re: SCT 4800
March 16, 2005 01:29
Dear Rosado,
I have SCSI board -04,plus cable and drive,
but I do not know software setting.
Actual system Rev is 1.30A
to rate and post a comment
Edwin Rosado
Re: SCT 4800
March 16, 2005 04:29
DearLazzari:
that is the latest software for the 4800. Verify the switch setting on the scsi board, mod setup, then connect everything to the console. The software will recognize the mod.
to rate and post a comment
Iftikhar Khan
Re: SCT 4800
March 19, 2005 03:18
hi
you have to set some switches and jumpers on DISK SCSI boar. if u connecting the MOD from the rear of the console then you need a scsi card and if u connecting the same from front side of DISK SCSI, then u dont need.
if you software is not compatible to Y2K, then u need to bring the date back before 2K.or the mod will not work for software, although it work fine for image archinving.
good luck
to rate and post a comment