Hello,
I have a OEC 6800 that had a Checksum error.
I replaced the CMOS Battery.
Set BIOS to the following:
Load Optimized Settings
Hard drive set to Manual
CPU set to 100/33/no
Now when the machine boots up, it gets stuck on "Waiting for generator Data" until it times out.
The result is no exposures.
Wondering if anyone has any suggestions?
Thank you
Lightly used system available direct from the end user customer. MONARCH QUEST
Featuring our most advanced, data-driven navigation software with AI-Powered algorithms & advanced imaging integration with the GE HealthCare OEC 3D C-arm.
Alan Jennings
OEC 6800 Mini C-Arm
August 02, 2019 09:29
Hello,
I have a OEC 6800 that had a Checksum error.
I replaced the CMOS Battery.
Set BIOS to the following:
Load Optimized Settings
Hard drive set to Manual
CPU set to 100/33/no
Now when the machine boots up, it gets stuck on "Waiting for generator Data" until it times out.
The result is no exposures.
Wondering if anyone has any suggestions?
Thank you
to rate and post a comment
Shawn Broussard
re: OEC 6800 Mini C-Arm
August 04, 2019 12:06
I had that happen once and just had to hook up with utility suites and reload the generator files, Regards
to rate and post a comment