APPL_STORAGE::ReadRecordInUse(int, void *) - (Zee), (Zee) This comes up when the application is loaded and will reset when pressing reset on the keyboard. Also comes up when switching from “run” to “application”. Once reset, unit works fine. Any suggestions? Thanks.
Michael Baumgartner
LoRad MIV bootup error message
December 02, 2010 06:10
APPL_STORAGE::ReadRecordInUse(int, void *) - (Zee), (Zee) This comes up when the application is loaded and will reset when pressing reset on the keyboard. Also comes up when switching from “run” to “application”. Once reset, unit works fine. Any suggestions? Thanks.
to rate and post a comment
Jose Vallejos
Re: LoRad MIV bootup error message
December 07, 2010 09:29
reload the application.
good luck,
to rate and post a comment