Can anybody help me how to control the developer temperature in Kodak M7B Processor. As there are no external switches or variables present for this purpose.
Response will be highly appreciated.
R1 is used to adjust the film clear time and is set so the processor will go into standby condition 3 minutes after the busser sounds, signifing that the film is past the entrance detector rollers.
John Chan
Kodak M7B Processor Temperature Control
May 29, 2003 09:04
Can anybody help me how to control the developer temperature in Kodak M7B Processor. As there are no external switches or variables present for this purpose.
Response will be highly appreciated.
to rate and post a comment
Colin Kelley Jr.
Re: Kodak M7B Processor Temperature Control
May 29, 2003 02:24
On the 100 board, pot R2 adjusts dev temp. CCW to decrease temp, CW to increase.
to rate and post a comment
John Chan
Re: Kodak M7B Processor Temperature Control
May 30, 2003 09:32
Also if you can tell what does R1 variable on the same board meant for.
What does this variable controls.
to rate and post a comment
Charles LaChance
Re: Kodak M7B Processor Temperature Control
May 30, 2003 03:47
R1 is used to adjust the film clear time and is set so the processor will go into standby condition 3 minutes after the busser sounds, signifing that the film is past the entrance detector rollers.
to rate and post a comment