Hi,
I have a problem with C Arm: GE Stenoscope,with 200DSM,
The lamp DS1 lights in red,and DS3,5,6&7 lights in green,
I read in the service manual that the problem might be a broken board inside the memory, or 24 vdc is not reaching the memory,but Im confused,which 24v is meant...if from the power supply inside the memory or from where else?
If any one got good experience with this memory,I would be grateful for help.
Thanks in advance
Alaa
Sell your scrap MRI magnets! Top prices, free shipping, and fast pickups. Don't let dust-collecting, idle assets go to waste. Contact: ryan.swiderski@cyclicmaterials.earth or call 437-826-1621
Alaa Mohammad
Help for a problem
November 13, 2019 01:33
Hi,
I have a problem with C Arm: GE Stenoscope,with 200DSM,
The lamp DS1 lights in red,and DS3,5,6&7 lights in green,
I read in the service manual that the problem might be a broken board inside the memory, or 24 vdc is not reaching the memory,but Im confused,which 24v is meant...if from the power supply inside the memory or from where else?
If any one got good experience with this memory,I would be grateful for help.
Thanks in advance
Alaa
to rate and post a comment