I need some help with my 5DI 5000. It seems to not penetrate past about 5cm. I can see some image below 5cm but it is faint. It doesn't matter what probe I am using(I have more than on variable Freq.) Adjusting the gain increases sound on the portion of tissues closest to the probe head but doesn't seem to change much past 5cm. Any thoughts?
Assuming the Output control setting has not been accidentally reduced, I would check the transmitter voltage power supply LED, the top one on the PSM. The transmitter voltages should be +/- 115vdc at maximum. (Use an adult abdominal or cardiac preset and make sure acoustic Output is at maximum.)
I don't have an adult abdominal setting. I purchased this machine with the hope of using it on dogs/cats(I am a veterinarian). I will check the voltage on the psm.
CC Medical provides reliable ultrasound systems, probes, system parts, & technical support serving hospitals and healthcare providers domestically & internationally. Wholesale pricing available. 833-309-4229. Se Habla Espanol sales@ccmedicalhs.com
TS
HDI 5000
May 11, 2017 03:44
I need some help with my 5DI 5000. It seems to not penetrate past about 5cm. I can see some image below 5cm but it is faint. It doesn't matter what probe I am using(I have more than on variable Freq.) Adjusting the gain increases sound on the portion of tissues closest to the probe head but doesn't seem to change much past 5cm. Any thoughts?
to rate and post a comment
Jim Carr
re: HDI 5000
May 12, 2017 07:45
Assuming the Output control setting has not been accidentally reduced, I would check the transmitter voltage power supply LED, the top one on the PSM. The transmitter voltages should be +/- 115vdc at maximum. (Use an adult abdominal or cardiac preset and make sure acoustic Output is at maximum.)
to rate and post a comment
TS
re: re: HDI 5000
May 13, 2017 09:08
I don't have an adult abdominal setting. I purchased this machine with the hope of using it on dogs/cats(I am a veterinarian). I will check the voltage on the psm.
to rate and post a comment
Brian Eberling
re: HDI 5000
May 12, 2017 07:46
Have you ran the diagnostics on the system?
to rate and post a comment
Tony Sheet
re: re: HDI 5000
May 13, 2017 09:12
No. Could you help me do this?
to rate and post a comment