You don't need RUS software, all what you need is an external monitor and keyboard. Boot the system with DOS bootable disk, at the prompt type copy C:\errlog.txt A:. Take the floppy disk out and read it on your computer or laptop. Good luck!!
The DOS boot floppy will most likely get you what you need, but if you're trying to pull down the generator event logs in RUS and nothing comes through, the coin battery on your X-Ray Controller/Generator Interface PCB (whichever of the two PCB's your system has) is dead. CR-2032 if memory serves.
hello Mohamed i am repairing a OEC 9800 and when the equipment boot show a error in the camr
ERROR VOLTAGE PRELOAD OFF WAIT 5 SEC reality the original error is:
ERROR VOLTAJE DE PRECARGA __APAGADO ESPERE 5 SEG just it is in spanish and never change
could you helpme pls
Specializing in GE, we keep your ICU monitors calibrated and patient-ready—fast, reliable service from expert biomed techs. Southeastern Biomedical: 888-310-7322.
Daniel Fernandez
Error log OEC 9800
February 27, 2009 11:09
Hi everybody.
I tried to get the error log from an OEC 9800 but I was unable.
Anybody know how to do it? I have the RUS software.
Thanks in advance.
to rate and post a comment
Muneer Abott
Re: Error log OEC 9800
March 03, 2009 08:07
You don't need RUS software, all what you need is an external monitor and keyboard. Boot the system with DOS bootable disk, at the prompt type copy C:\errlog.txt A:. Take the floppy disk out and read it on your computer or laptop. Good luck!!
to rate and post a comment
Daniel Fernandez
Re: Error log OEC 9800
March 03, 2009 11:35
Thank you Mohamed. I will try it!!
to rate and post a comment
Wes Boyd
Re: Error log OEC 9800
August 24, 2009 10:34
The DOS boot floppy will most likely get you what you need, but if you're trying to pull down the generator event logs in RUS and nothing comes through, the coin battery on your X-Ray Controller/Generator Interface PCB (whichever of the two PCB's your system has) is dead. CR-2032 if memory serves.
-Wes
to rate and post a comment
manuel valdez
Re: Error log OEC 9800
October 29, 2009 10:38
hello Mohamed i am repairing a OEC 9800 and when the equipment boot show a error in the camr
ERROR VOLTAGE PRELOAD OFF WAIT 5 SEC reality the original error is:
ERROR VOLTAJE DE PRECARGA __APAGADO ESPERE 5 SEG just it is in spanish and never change
could you helpme pls
to rate and post a comment