DirectMed Imaging specializes in Equipment Sales, Parts, and Support. Parts are in stock and available for immediate delivery. In-room MRI Upgrades are available now. (855) 463-3727 or sales@directmedimaging.com
Justin Cooper
October 08, 2012 08:38
Dear Hi I have Varian Tube for my GE CT lightspeed plus The hardware stop scan when I perform tube warm up I got the below log error when I perfo...
Justin Cooper
June 12, 2026 06:49
Looking for some help on this error on a GE Lightspeed Plus STC axial board reports a CF error 2104 System will not do rotating X-ray-on and scans int...
Jim Foros
October 06, 2012 02:08
Had to do a load from cold on a Signa Ovation due to a failed disk drive After that I manually enter the basic config info in the guided install tabs ...
Posted by an Anonymous July 13, 2016 07:55
I am in need of konica printlink III password please somebody help me...
Adrian Castelli
October 05, 2012 06:03
I have got a Choice MMED6000 monitor for repair Has anybody got the engineer password not the system password Thanks Adrin ...
50+ Stretchers in stock for immediate rentals. Contact us for a today for a quote.
Posted by an Anonymous October 05, 2012 10:04
Probe device 3d s-VAW 4-7 4d does not work Message option not implemented please help me...
Gianluca Ranieri
November 13, 2012 10:29
Dear I need help with GE PROFILE upgraded to 4 I lost a information of NVRAM and system dont recognize a software option PN of Host is 2315587 Plea...
Fadhl Alakwa
October 04, 2012 08:44
Hi My system GE LSX3 has the following error the hardware reset failed When I replaced the STC ARTESYN III board the error disappear and I got anoth...
Posted by an Anonymous October 01, 2012 04:47
Need support for installation of GE Profile IV open MRI...
kevin barnes
December 01, 2017 04:30
Does anyone know the service password to the GE Logiq P5 sonogram system Thank you...
HIGH QUALITY fully tested & refurbished systems to manufacturer specifications like new. Installation & service support worldwide. Parts & tubes in stock with warranty. Sales@Elsmed.com
Victor Gutierrez Ferro
February 16, 2013 09:32
I have an issue with a Planmeca PM 2002 EC Proline it is while is rotating does a noise and stops almost it continues again but slower at the end sho...
Rufat Nasibov
October 01, 2012 04:46
Looking for experienced installation technician for GE LightspeedBrightspeed 16 System shall be installed in Azerbaijan Knowledge of Russian or Turkis...
Posted by an Anonymous September 28, 2012 08:26
Hello all we have an Intera 15T Philips system that is giving an intermitent RF error On the log it reports the Max RF Field exceeded detected by PU-c...
Posted by an Anonymous September 28, 2012 08:24
I got problems in a GE MRI Signa contour 3 Gradient amplifier can not be recoverd Any idea about this problem Thank you...
GE Precision Long CAN Control Amplifier Inoperative
Michael Baumgartner
October 08, 2012 06:11
The Long CAN Control Amplifier blinks red Suspect defective Tried replacing CAN Amp downloading firmware update but is unsuccessful DIP address is ...