CSZ Cincinnati Sub-Zero 400MR Cooler Heater System
Surgical Cardiovascular Hyper-Hypothermia Unit & Hoses
Purchase instantly by clicking the Buy Now button above. I will invoice freight shipping separately.
This Hemotherm 400MR Cooler Heater System is in excellent cosmetic and fully tested working condtion. It is complete and ready to use and I guarantee it will not be DOA. Quickly heats and cools the reservoir tanks to the proper set temperature and the pump is strong.
Comes with the Hemotherm 400MR Cooler Heater, Hoses, Operating/Service Manual (on disk) and attached power cord. This device has two reservoirs (cold & hot) which are filled with water. It quickly cools and heats the respective reservoirs so the water can be pumped through the blanket or heat exchanger for surgical or cardiovascular procedures. It is a microprocessor controlled with electronic displays. Water temperature can be digitally set from 3C to 42C. There are high and low temperature alarms and the pump is strong. (see pic) It only took a few minutes for both reservoirs to reach max low and max high temperatures. I used my digital thermometer to confirm reservoir temperatures properly corresponded to the digital displays. Both reservoirs are clean and have lids. If you are needing a good solid hyper-hypothemia machine and dont have a big budget then this is the system for you. Nice system!
CSZ Cincinnati Sub-Zero Hemotherm Cooler Heater
Surgical Hyper-Hypothermia System
Serial No: 933-10141M
115 Volts - 60 Hz - 16 Amps
Compressor: 1/2 HP
Adjustable Temp: 3 Celsius to 42 Celsius (37.4 Fahrenheit to 107.6 Fahrenheit)\
High/Low temperature alarms
70 Page Operation & Technical Manual (scanned copy on disk)
2 Tubing set (in/out) w/ gate valves & connectors
Extra long 20 foot hospital grade cord.
Manufacturer's Description from Manual-
The CSZ HEMOTHERM Model 400MR Cooler/Heater system is used to lower/raise the blood temperature and/or maintain blood temperature, as required, through conductive heat transfer. The conductive heat transfer is accomplished through any type of Blood Oxygenator/Heat Exchanger unit, along with the use of a blanket under the patient for the re-warming phase, if desired. The complete system usually comprises of the HEMOTHERM Cooler/Heater unit and reusable or disposable blanket on the O. R. TableAdult, Pediatric, or Infant size. Available blankets are : the reusable PLASTIPAD® blankets (polyurethane) and the disposable MAXI-THERM®, MAXI-THERM® LITE, and TEMP PAD® blankets.
With a capacity to lower the water temperature at a 2°C/minute rate, a reduction of blood temperature is produced. It is important to remember that there is no direct relationship between this and the rate of change in the blood temperature. The re-circulation pump and water flow circuitry have been designed for high flow rate to maximize the blood-towater heat transfer efficiency. The cooling system's temperature controller allows the operator to set the temperature range from +3°C to +32°C. An independent Low Limit Safety in the microprocessor board provides the low limit safety function and is factory preset at 2°C.
The HEMOTHERM 400MR cooling system consists of:
1. A mechanically refrigerated water-to-refrigerant heat exchanger.
2. Chilled water reservoir.
3. Water re-circulation pump.
4. Microprocessor control system.
5. Low temperature safety.
6. Low water cut off safety.
The CSZ HEMOTHERM heating system consists of:
1. 300 Watt Heater.*
2. 1200 Watt Heater.*
3. Microprocessor control system.
4. Hot water reservoir.
5. Water re-circulation pump.
6. High temperature safety.
7. Low water cut off switch.
This system is in perfect operating condition. It has been fully tested in cooling and heating modes. I filled the reservoirs with distilled water and they quickly reached max and min temperatures in approximately 5-7 minutes. The temperature of the reservoirs are maintaning the exact display temperatures according to my digital thermometer. The pump is operating strong and recirculating a lot of water when activated. The case finish is nice with some sign or normal wear in the form of a few paint chips and scratches but damage. All indicator lights and alarms are working. The reservoirs are clean. All displays and controls are working properly. The hoses are good and all connectors and valves are working properly. There are no leaks. A small portion of the manufacturer's label has been scratched off but it is still legible. Nice system.
Hemotherm: 23" wide x 32" tall x 24" front to back
(2) 8 foot hoses
Power Cord: 20 feet long
I stand behind everything I sell and I guarantee this Hemotherm 400MR is exact to the description and pictures I have provided here or return it for a refund.
This unit weighs 204 lbs and will require freight shipping. To give you some idea it will cost approximately $170.00 for west coast shipping and approximately $235.00 for east coast shipping. Residential, limited access or lift gate service will cost extra. Contact me with your shipping address for an exact quote.
Pallet weight will be 255 lbs, NMFC is 133-300, Machine System NOI, Dimensional Freight Class is 92.5, Pallet Dimensions is 32x30x40
Pickup is always welcome. located in Coolidge Arizona 85128 which is 40 miles SE of Phoenix Az near I-10
All other international buyers must contact me prior to purchasing for a shipping quote and determination whether this item will ship feasibly to your country. It is large/heavy and will be expensive to ship internationally.