Hello dear collegue. I have a some strange proplem with Voluson 730 Pro. If switch on 3D or 4D scanning, mashine give me error message what need disconnect probe or change probe. After this message i have message error for waiting taim for RS232. Ichange probe the same typy and anather typa but dont have a positive result. Pleas if enebody now how to solve this proplem answered me.
Do you have this mode enabled by codes?
It won't work without them. Dunno for errors,
maybe it's hardware problem that needs repair.
But the 4D mode definitely needs to be enabled specially.
please chek whit anoder probes 4D.if has this error some cabel is disconect in the main board.but you have this error in this probe the defective motor rotitive for 4D.
Andrey Nesterov
Voluson 730 Pro
May 16, 2010 10:09
Hello dear collegue. I have a some strange proplem with Voluson 730 Pro. If switch on 3D or 4D scanning, mashine give me error message what need disconnect probe or change probe. After this message i have message error for waiting taim for RS232. Ichange probe the same typy and anather typa but dont have a positive result. Pleas if enebody now how to solve this proplem answered me.
to rate and post a comment
(1)
Thomas Garbler
Re: Voluson 730 Pro
May 20, 2010 09:40
Do you have this mode enabled by codes?
It won't work without them. Dunno for errors,
maybe it's hardware problem that needs repair.
But the 4D mode definitely needs to be enabled specially.
to rate and post a comment
(10)
kyriakos drakos
Re: Voluson 730 Pro
July 19, 2010 09:04
i have it kyriakos_flo@hotmail.com
to rate and post a comment
(3)
(1)
morteza yousefi
re: Voluson 730 Pro
October 11, 2013 06:05
please chek whit anoder probes 4D.if has this error some cabel is disconect in the main board.but you have this error in this probe the defective motor rotitive for 4D.
to rate and post a comment