From CA to NY and around the world we buy and sell your used imaging equipment at market value or higher. We offer spare MRI and CT parts, accessories and services supporting most OEMs. We also offer purchase, long or short-term Mobile MRI & CT rental.
(4)
WG
Siemens avanto shimmed but won’t pass phantom shim in tuneup
September 14, 2021 11:44
Hi all, any advice here would be appreciated. Siemens avanto is in shim specification. However, phantom shim in tune up won’t pass but it will in expert mode with the body coil and phantom with body loader or in expert mode with a head coil and small ball phantom. I don’t understand why I can get phantom shim to pass willingly expert mode but not in normal tune up mode. When the system boots all options in system control are fine and it boots normally. Gradient polarity has been checked and is wired normally. Any thoughts or offers of help would be appreciated. Software is VB19.
to rate and post a comment
(14)
(1)
sford
re: Siemens avanto shimmed but won’t pass phantom shim in tuneup
September 29, 2021 10:32
possibly vibration in the phantom?
to rate and post a comment
Bilal Ahmed
re:Siemens avanto shimmed but won’t pass phantom shim in tuneup
October 12, 2021 10:04
problem in shim unit. confirm it by going into configration and select advance shim unit not istalled, save it. reboot scanner run phantom shim. if it runs than problem in shim unit or related section.
to rate and post a comment